IDSM-2
The IDSM-2 Module is a Cisco IDS blade for the Cisco 6500 switch.
Once you install the module into the switch the module uses following logical ports :
Once you install the module into the switch the module uses following logical ports :
Port 1 | Used for TCP Resets (In Promiscuous Mode) |
Port 2 | Command and Control |
Port 7 | Sensing Port |
Port 8 | Sensing Port |
Below details the steps required for
configuring your switch / module for an inline setup. This includes obtaining
the module number for the cisco ids running the setup wizard and then assigning
the required ports for on the switch for ids sensing within an inline
configuration. The clear trunk commands are required as by default the switch
assigns the ports as trunk ports to every vlan.
switch >
(enable) show module
switch > (enable) session [module]
isdm-2# setup
switch > (enable) set vlan 50 5/7
switch > (enable) set vlan 51 5/8
switch > (enable) clear trunk 5/7 1-49, 51-4094
switch > (enable) clear trunk 5/7 1-50, 51-4094
switch > (enable) session [module]
isdm-2# setup
switch > (enable) set vlan 50 5/7
switch > (enable) set vlan 51 5/8
switch > (enable) clear trunk 5/7 1-49, 51-4094
switch > (enable) clear trunk 5/7 1-50, 51-4094
NM-CIDS
The NM-CIDS is the IDS module for Cisco Routers.The config below
allows you to assign an ip address to the sensor which will only we accessible
via a route or via a reverse telnet from the router itself. This a security
measure to ensure that your IDS modules IP address isn't fully accessible.
router(config)
# interface loopback 0
router(config-if) # ip address 1.1.1.1 255.255.255.255
router(config-if) # exit
router(config) # interface ids-sensor 1/0
router(config-if) # ip unnumbered lo 0
router(config-if) # exit
router(config) # ip cef
router(config-if) # ip address 1.1.1.1 255.255.255.255
router(config-if) # exit
router(config) # interface ids-sensor 1/0
router(config-if) # ip unnumbered lo 0
router(config-if) # exit
router(config) # ip cef
Under each interface use the following command to initiate the packet monitoring
router
(config-if) # ids-service-module monitor
Access the NM-CIDS Console
router #
service-module ids-sensor x/y session
router # telnet [router ip] [port number - port
number = (32 * port number) + 2001]
Maintenance Commands
router # service-module ids-sensor x/y ...
reload
reset
session
shutdown
status
reload
reset
session
shutdown
status
No comments:
Post a Comment